Saturday, December 31, 2011

TODAY ONLY TILL MIDNIGHT! $100 POWDERED AND SHIPPED!

WINGUS BARS,
10 AND 12IN ZOMBIE APES,
WTF BARS,
QUARTER RACERS,
CLOWN CAR BARS,
and UPSWEEPS!









1in and 7/8's bars in stock sizing only! Raw, Black, or White powdercoat.
FREE SHIPPING TO THE CONTINENTAL USA ONLY. ONLY TILL MIDNIGHT AND NOT A MINUTE MORE!

JUST VISIT THE STORE!

Friday, December 30, 2011

Flash Back Friday





Wiring Reliefs!

If your running your switches on you bars then I need to cut these reliefs in your bars. Its the equivalant of "Dimples". 

I'll need you to measure from the OUTSIDE of the bars to the END of your grip [were the switch housing and grip meet]. And then again from the END of the bars to the END of your Lever Clamp [total length of your controls]. I try to make it so that you'll have a 1/2in opening once your controls are installed so, accuracy is key.

If your going for INTERNAL WIRING, I just need to know where your switch housing starts and stops measured from the end of the bars. This way the relief cut sits inside your switch housing and can not be seen.


Steffan
Zombie Performance
www.zombieperformance.com

Chubby 1.25in Wingus Bars!

Fat 1.25 tubing with 6in of 1in tubing for the clamps and 8in of 1in tubing for the grips. These monsters are 31in wide and have 4in of pullback. There is also a relief in them to clearance your mastercylinder. There are no dimples or reliefs for your switches but I'll add them if you need them.


Steffan
Zombie Performance
www.zombieperformance.com

Wednesday, December 28, 2011

Customer Springer Bars


This customer wanted me to build him a bar similar too what CRO CUSTOMS is working on. After a little bit of back and forth between the three of us, we got Calebs blessing to build something similar too his bars. These are set up with an Exile internal throttle and built off of a DNA springer top clamp.

Mr. Owens is going all out on his original Cro Bars. Hes building his own top clamp. So fa,r what i've seen is top notch. Check it out! http://crocustoms.blogspot.com/2011/11/cro-bars-original.html



Steffan
Zombie Performance
www.zombieperformance.com

Tuesday, December 27, 2011

NEW DIES!

Hell yes! I'm excited! I ordered a custom 2.5clr die and a monster 4.5clr die for 1in tubing. Now with the 3clr die and these two I have lots of bend options for 1in bars.

I also picked up a 1.25in 3.5clr die. Chubby bars here I come!


Steffan
Zombie Performance
www.zombieperformance.com

Tanked Up Tuesday

Great Divide YETI Imperial Stout

This is one flavorful fucking beer! Not for the timid or Pabst loving variety.


Steffan
Zombie Performance
www.zombieperformance.com